Welcome to Control Devices Engineering

This is a short instructional video on how to change out pins on the AMP 16 Way connector for the MOBICON PROJECT

I have made a video on how to configure a Ditel PICA100 P6 with a Penny and Giles STT tilt sensor 10 (degree). The video shows how to configure the sensor display meter and trigger the relays at a designated voltage reference.

Continues on for the original article which can be found HERE.

Today we have completed a rough desing and model of a test rig which we will use to test the selected micro switches for the new JC6000 Micro-switched prototype.

We will be testing the device under load and log the information electronically. We will be testing contact resistance during the test. This should allow us to plot the changes in the device and determine it’s actual useful life.

The tests will be performed at 4 Hz  switching cycle.  By my calculations we should be able to test well past a million cycles within 3 days.

This video explains the setup of the Penny and Giles SLS sensor with the SSC conditioning module. This first part explains how to set up the SSC with the SLS sensor

This video explains the setup of the Penny and Giles SLS sensor with the SSC conditioning module. This first part explains how to test the SLS sensor.

CDG-GEN-0099 is a filter monitoring box, that monitors 4 filters. this is a custom job for Bosch Rexroth in Western Australia.
The device check the normally closed switch that is engaged when the filter is functioning normally, if a filter needs servicing the switch opens and the monitor box registers a fault. when a fault is detected the 24V signal to the PLC falls to 0v and can only be reset when the filter switch is back into the closed position after maintenance.

How to fix an XMR switched joystick into a panel.

How to put on the additional protective sleeve for the Penny and Giles SLS sensor.

This is a quick video of the new PCB for the new version of the PCB.

Control Devices Penny and Giles HS00 head replacement instructions for MJE

Control Devices Penny and Giles A400 plate replacement instructions for MJE

This is a short video showing a refleftice sensor and a panel meter set up to operate as a tachometer system. The tachometer can be set up to trigger alarms or relays to indicate overspeed or other warnings.

Seika NG2I connected to Ditel Pica display, showilng angle position and triggering relays at set points. The setpoints can be set anywhere accross the voltage span of the sensor.

This video file shows how to disassemble the SLS series of sensors. This is useful for servicing the seal kit for the sensor and it also allows you to see if the wiper contacts are intact. This video applies to all SLS130, SLS190 and SLS320 units.